|
||||
热电偶专用高温电缆High Temperature Cable Special For Thermocouple本产品为热电偶专用的高温连接线。产品具有优良的耐腐蚀性能,几乎不溶于任何 ,可耐油、耐酸碱等;具有优良的电绝缘性能,不吸潮,绝缘电阻大;具有阻燃性能。The cable is a special high temperature connecting wire of thermocouple. It has many good features such as excellent corrosion resistance, almost insoluble in any organic solvents, oil resistance, acid resistance, better electrical insulating properties, moisture resistance, big insulated resistance, flame resistance and so on. 一、产品执行标准 企标 Executive standard: enterprise standard二、型号KX-H-5FPF2高温补偿导线KX-H-5FPF2高温补偿导线[股份@有限公司]欢迎您控制器主要由指令寄存器、 、程序计数器、操作控制器等组成。存储器存储器是计算机记忆或暂存数据的部件。存储器分为内存储器(内存)和外存储器(外存)两种。输入设备输入设备是给计算机输入信息的设备,负责将输入的信息(包括数据和指令)转换成计算机能识别的二进制代码,送入存储器保存输出设备输出设备是输出计算机结果的设备,大多数情况下,它将这些结果转换成便于人们识别的形式。输入设备和输出设备常常被简称为I/O设备。 Type型号type 名称descriptionAKFFPXR200 K型热电偶专用高温屏蔽电缆High temperature shielding cable special for K type thermocoupleANFFPXR200 N型热电偶专用高温屏蔽电缆High temperature shielding cable special for N type thermocoupleAEFFPXR200 E型热电偶专用高温屏蔽电缆High temperature shielding cable special for E type thermocoupleAJFFPXR200 J型热电偶专用高温屏蔽电缆High temperature shielding cable special for J type thermocoupleATFFPXR200 T型热电偶专用高温屏蔽电缆High temperature shielding cable special for T type thermocouple三、使用特性 operating characteristics 1、工作温度:电缆导体长期工作温度为200℃。 Long term operating temperature of cable conductor is 200℃.KX-H-5FPF2高温补偿导线KX-H-5FPF2高温补偿导线[股份@有限公司]欢迎您底坑导轨座必 mm,并用混凝土将四周灌平;检查导轨的直线度不大于1/6000,不符合要求的导轨必须进行校正或更换。检查导轨端部榫头、榫槽是否有损伤,清洁干净后,才可以进行;用卷扬机逐根吊起导轨,由下向上,顶层末端导轨应根据实际长度,将导轨截断后吊装;用校轨尺对导轨自下而上调整,发现有偏差时立即纠正。存在问题:导轨完后,电梯运行平稳。但是经过一年的运行,电梯左右晃动比较厉害;导轨箱后没有按标准摆放在库房内,致使导轨生锈、扭曲。 2、弯曲半径:电缆弯曲半径不低于电缆外径的10倍。Bending radius of cable shall be no less than 10 times that of cable outer diameter.&n 5。 Flame resistant characteristic shall meet the requirements speculated in GB19666-2005 standard.四、性能参数表Performance parameter项目Item 单位Unit 技术指标Technical Indices绝缘电阻Insulated resistance MΩ 25电压试验Test voltage V 500V 1min 不击穿Finished cable shall endure 500v voltage test for 1 min without puncture.KX-H-5FPF2高温补偿导线KX-H-5FPF2高温补偿导线[股份@有限公司]欢迎您理解起来可能有点拗口,应用起来知道怎么就行。步:看是单极性,还是 :调用模块。第三步:分别给两个模块的MIN,MAX,VALUW赋值即可。注意其数据类型,一般的%IW0为INT,转换后位REAL。 |
|